37 7. Super Automatic Mode; 37 7.1 Mode Activation And Deactivation; Test Sequence - Beissbarth SL 6 Serie Manual Original

7. Super automatic mode
i
Super automatic mode is recommended for full
testing of a vehicle requiring verification of the
measured data.
Features of super automatic mode:
R
Specified test sequence (sub-tasks).
R
Automatic starting of measurements.
R
Automatic storage of measurement results.
R
Automatic print-out of measurement results.
7.1 Mode activation and deactivation
Step
¶
Activate super automatic mode.
¶
Deactivate super automatic mode.
7.2

Test sequence

Step
1. Check prerequisites:
R
No vehicle on dynamometer!
R
Tester/test routine selected.
R
"Super automatic" mode selected.
!
It is essential to comply with the test sequence
(sequence of sub-tasks)!
The rest of the test sequence is similar to Automatic mode (Section 6).
Beissbarth GmbH
Super automatic mode | SL 6xx | 63
i
The following applies in super automatic mode:
$
Termination of the test sequence (Automatic but-
ton or STOP) causes all the stored values to be
deleted (Clear All).
$
If the test sequence is not continued, the SL 6xx
returns to manual mode after approx. 5 minutes.
The stored values are deleted (Clear All).
$
Auto-termination of the order after a pre-config-
ured time period.
i
Special features of ST 600 test sequence
$
Automatic resetting of incorrect measurements:
If no subsequent measurement is taken, the first
toe measurement is identified as an incorrect
measurement and is rejected.
Remote control unit Result / Display
 Mode indicator:
"Super automatic" symbol
+
Press one after the other
 Mode indicator:
"Manual mode" symbol
Press STOP
Result / Display
 Left: Device identifier and current sub-task:
1 = Front axle.
2 = Rear axle.
P = Parking brake.
 Right: Drive-on prompt.
en
|
1 691 706 020 2012-12-11