Remote Kit Installation; Installation Set Up - Empire EFRC Guia De Instalacion

Remote Kit Installation

Installation Set Up

1. Open steel curtain (remove
glass doors if applicable).
2. Remove two screws on log
grate and remove log grate.
(Figure 1)
3. Pull front edge of plastic ember
bed grate up and forward until
rear tab releases from the
ledge located at the bottom of
the mirror. (Figure 2)
!
NOTE: Log set fits tightly into
firebox, some force may be
necessary to remove.
4. Locate and remove the two
screws on the removable
bracket. Remove the bracket.
(Figure 3)
5. Locate and depress the
mounting tabs on the plug
connector to remove it'.
(Figure 3)
!
NOTE:
Keep the plug
connector in a safe place. You
will need it if you decide to
uninstall the remote control to
operate the fireplace manually.
Figure 1
Screws
Manual Controls
Figure 2
Back
Ledge
Rear
Tab
Side Section
Figure 3
Removable
Bracket
Log
Ember
Bed
Front
Edge
Depress
Mounting
Tabs
5