Care And Cleaning; Cleaning And Maintenance; For Your Safety - GE G8H0AASSPSS Manual Del Propietário

Care and Cleaning

Cleaning and Maintenance

Always clean the motor body and blending shaft
thoroughly after using. Remove the blending shaft from
the motor body. Clean the motor body only with a sponge
or damp cloth. Do not use abrasive cleaners which could
scratch the surface. To clean the blending shaft, wash by
hand in hot water using mild detergent. Be mindful of the
permanently mounted razor-sharp edges.
CAUTION

FOR YOUR SAFETY

NEVER immerse the motor body in water or other
liquids.
When the appliance has malfunctioned or has been
dropped or damaged in any way or is not operating
properly, contact the manufacturer at the website listed
in the Contact Us section for information on examination,
repair, or adjustment Any other servicing should be
performed by an authorized service representative.
49-9000008 Rev. 0
Chopper/Grinder Attachment
To simplify cleaning, rinse the prep bowl, cover, and
blade immediately after use, so that food won't dry onto
them. Wash blade ring, plastic sheath, and prep bowl in
warm soapy water. Rinse and dry. Wipe the underside of
the chopper/grinder cover with a sponge or damp cloth
to remove any food. Do not submerge the cover in water
or put in the dishwasher. Wash the blade carefully. Avoid
leaving it in soapy water where it could disappear from
sight. If you have a dishwasher, you can wash the prep
bowl blade assembly on the upper shelf. Insert the prep
bowl upside down. Put the blade in the cutlery basket.
Unload the dishwasher carefully to avoid contact with
the sharp blade. Wipe the motor body and top of the
cover with a damp sponge or cloth. Dry it immediately.
Never submerge the motor body or the cover in water or
other liquid. The chopper/grinder attachment is intended
for HOUSEHOLD USE ONLY. Any service, other than
cleaning and normal user maintenance, should be
performed by an authorized Service Representative.
Whisk attachment
To clean your whisk attachment, simply release the
attachment from the motor body housing. Once the whisk
is removed, detach the metal whisk from the gearbox
by pulling pieces apart. To clean the gearbox, simply
wipe with a damp cloth. To clean the metal whisk, wash
with warm, soapy water or in the dishwasher. Do not
submerge the gearbox in water or any other liquid.
7