Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The machine may be fully assembled, however this
MONTAGEM DO APARADOR DE GRAMA:
Insert the upper parts into lower part firmly until a "click" is heard.
NOTE: the screw holes should be on the same side.
GUARD FITTING:
01
Position motor head/axle as shown in
(FIG4), with screw fixing hole at the top
centre. (remove pre fitted screw).
02
Position guard with inner side, ie.
moulding facing you as shown in (FIG5).
Lower the guard over the motor head/
03
axle (see FIG6) and align slots as shown
in (FIG7) (note position of the tab).
04
Align marks on head of the unit and
the guard, turn the guard in a clockwise
direction. see (FIG7).
WARNING! Take great care
when doing this as the guard has
a very sharp cutting edge.
ASSEMBLY INSTRUCTION
instruction gives you full assembly details.
FIG 1
FIG 2
Remove the screw
located before fixing
the protection.
Guide
Put dow as shown
untill the position.
FIG 3
FIG 4
FIG 5
FIG 6
DANGER:
Sharp blade!
23
Publicidad
Tabla de contenido
