How To Perform A Dry Using A Standard Program; How To Perform Drying Using User-Defined Values; User Menu - Primer DSD-11 Guía Rápida De Manejo

(2) The End / Anti-crease cycle lasts a maximum of 99 minutes. During this period, an alarm will
sound every three minutes, reminding you that the cycle has finished. After 99 minutes the
machine returns to the status: Pause.
1.3.1.2 HOW TO PERFORM A DRY USING A STANDARD
PROGRAM
When the machine is on STANDBY, press the arrow keys to select desired program.
When the display shows the desired program press START / STOP, and then it launches the
desired program.
1.3.1.3 HOW TO PERFORM DRYING USING USER-DEFINED
VALUES
When the machine is on STANDBY, press the SELECT key until 60º is displayed flashing (drying
temperature) and modify it with the arrows.
Pressing again SELECT to display flashing drying time, 25' and change the time using arrows.
Press START / STOP to activate the drying performance.
These values can also be changed with the machine running.

1.3.1.4 USER MENU

With the dryer switched on and without running any programme, press the PROG key
three times. The microprocessor will request a password (Code).
To access the user menu you must enter code 1-3-5-7. Use keys INC () and DEC
() to change the digits and with the SELECT key you can go from one digit to another.
When the four figures have been entered, press SELECT to go to the User menu.
PASSWORD
* * * *
PASSWORD
35