Kohler K-1630 Guia Del Usuario página 2

5-1/8"
(13 cm)
35-1/2"
(90.2 cm)
1/8"
(3 mm)
Product Information
Pump on right, integral flange
Pump on right, integral flange
Fixture:* basin area
Bathing 43" (109.2 cm) x
well 28" (71.1 cm)
water depth
To 13" (33 cm)
overflow
* Approximate measurements for comparison only.
Pump HP
1-speed 1-1/4 HP
Heater kW
1.5 kW
Required Electrical Services (2)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Heater
Locate the outlets behind the whirlpool and within 24" (61 cm)
of the pump and heater.
Installation Notes
Install this product according to the installation guide.
Floor support under whirlpool must provide for a minimum of 80
lbs./square foot (390 kg/square meter) loading.
If installing a rim mount faucet, make sure there is no interference
1014742-1-B
K-1630-H
30" (76.2 cm)
59-3/4" (151.8 cm)
1" (2.5 cm)
K-1630-H shown
K-1630-HK not shown
top area
52" (132.1 cm) x
32" (81.3 cm)
capacity
55 gal. (208.2 L)
Voltage Frequency Amperage
120 V 60 Hz 7.5 A
Voltage Frequency Amperage
120 V 60 Hz 12.5 A
120 V, 15 A, 60 Hz
120 V, 15 A, 60 Hz
12-1/8"
(30.8 cm)
42-1/2"
(108 cm)
Pump/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H Min.
23-1/4"
(59.1 cm)
17-1/2"
(44.5 cm)
with drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
This fixture conforms to ANSI Standard Z124.1. All dimensions are
nominal.
weight
120 lbs.
(54.4 kg)
2
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
1-1/8"
(2.9 cm)
3/4"
(2 cm)
3/8" R.
(1 cm)
Integral Flange Detail
2-7/8" (7.3 cm)
3" (7.6 cm)
1-1/2" O.D.
3/16" R.
(5 mm)
8"
(20.3 cm)
Kohler Co.