KNOVA KN RO-1200 Manual Del Usuario página 5

OPERATION
WARNING: To prevent personal injury, always discon-
nect the plug from the power source before assembly,
adjustment or changing of bits. Failure to comply with
these instructions could result in accidental start-up
and possible injury.
INSTALLING/REMOVING THE ROUTER BIT (see Fig. 2)
To install the bit
• Unplug the router.
• Remove the detachable chip shield (11).
• Keep the spindle lock (5) depressed and rotate the spindle
until the spindle lock fully engages.
• Place the router upside down on a smooth, flat surface.
• Loosen the collet nut (6) using the spanner wrench
provided. Insert the shank of the router bit into the collet.
• Keep the spindle lock button (5) depressed and tighten the
collet nut (6) using the spanner wrench provided.
• Release the spindle lock.
To remove the bit
CAUTION: Burn hazard. The router bits get hot dur-
ing use. Allow sufficient time for the bit to cool before
replacing it.
• Keep the spindle lock button (5) depressed.
• Loosen the collet nut (6) using the spanner wrench
provided and remove the bit.
• Release the spindle lock.
ADJUSTING THE DEPTH OF CUT (see Fig. 3)
WARNING: Turn the router off and disconnect it from
the power supply.
The depth of cut is the distance between the depth stop bar (8)
and the depth stop turret (7). The depth of cut can be set in two
different ways as follows:
ADJUSTING THE DEPTH OF CUT USING THE SCALE
• Unplug the router.
• Loosen the locking screw (12).
• Pull the plunge lock lever (4) up.
• Lower the router until the router bit touches the workpiece.
• Push the plunge lock lever (4) down.
• Move the pointer to the zero position on the scale (9).
• Add the desired depth of cut to the starting position.
• Move the depth stop bar (8) to the calculated position
on the scale.
• Tighten the locking screw (12).
• Fine adjust using the adjusting knob.
• Pull the plunge lock lever (4) up and let the router
return to its original position.
• Switch the router on, then lower the unit to make
the desired cut.
WARNING: To reduce the risk of injury, do not over-
load the tool. Let it work at its own pace. Guide the
cord carefully to avoid accidentally cutting it.
Adjusting knob
Pointer
Fig. 3
ADJUSTING THE DEPTH OF CUT USING A PIECE OF WOOD
• Unplug the router.
• Lower the router as described above.
• Pull the depth stop bar (8) up.
• Between the depth stop turret (7) and the depth stop
bar (8), place a piece of wood with a thickness equal
to the desired depth of cut.
• Tighten the locking screw (12).
• Fine adjust using the adjusting knob (21).
• Remove the piece of wood.
• Pull the plunge lock lever (4) up and let the router return
to its original position.
• After switching the router on, lower it to make
the desired cut.
Fig. 2