Uniteck UNICHARGE 1,5.12 Manual Del Usuario página 18

EN
MANUAL MODE / MANUAL LOAD (UNICHARGE 4.12 AND 8.12)
If your battery is severely discharged (very low voltage <5V) and therefore not recoverable with
automatic charging, select manual charging mode.
UNICHARGE will force the charge until the battery reaches a voltage of 13.6V. After this mode, your battery
will be recharged to 80%. We recommend that you finalize the load with an automatic load.
WARNING
!
- Before starting the mode, be sure to disconnect your battery from any electrical circuit
including vehicles.
- The reverse polarity protection is inactive; any connection error is irreversible for the charger
(out of warranty).
- Do not let the charger connect more than 12H in manual mode
RECONDITIONING MODE. (UNICHARGE 8.12)
This function is used to rehabilitate batteries that have lost their ability to store energy due to the stratification
of their electrolyte. Lamination is a non-homogeneous mixture of the electrolyte. Water having a lower
density, it concentrates with time upwards while the acid, having a higher density, concentrates downwards.
With the RECONDITIONING mode, UNICHARGE delivers a specific charging curve that stirs the electrolyte so
that the battery recovers its capacity to store energy, thus increasing its lifespan.
WARNING
!
- Before starting the mode, be sure to disconnect your battery from any electrical circuit
including vehicles.
INTEGRATED PROTECTIONS
For safe operation, Unicharge has several built-in protections that preserve the charger and the battery:
- Reverse polarity protection,
- Short-circuit protection,
- Thermal protection (except Unicharge 1.5.12)
- Protection against sparks.
18/34
www.uniteck.fr