Use Instructions - Mychanic 52608 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

23.
This product is not a toy. Do not allow children to play with or near this item,
and store out of reach of children.
24.
Maintain product labels and nameplates. These carry important safety
information.
SETUP PRIOR TO USE
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning
of this manual before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages,
refer to the Parts List and Assembly Diagram section.
IMPORTANT! Before first use:
Check hydraulic oil level and fill to 1/4" (6 mm) below the fill port as needed as
stated below. Thoroughly test the jack for proper operation. If it does not work
properly, bleed air from its hydraulic system as stated below.
TOOL SET UP
Attaching the Handle
1.
Attached the upper handle to the lower handle.
2.
Loosen the set screw and insert the assembled handle into the handle
socket.
3.
Tighten the set screw.

USE INSTRUCTIONS

BLEEDING
Before each use or if jack performance decreases, check for excessive air and
proper hydraulic fluid level in jack. If jack appears to not be working properly, it
may be necessary to purge its hydraulic system of excessive air as follows:
1.
Loosen the fill screw.
2.
Twist the handle counterclockwise to open the valve.
3.
Check fluid level and, if necessary, top off according to Adding Hydraulic
Fluid below.
4.
Twist the handle clockwise to close the valve, then pump the handle
quickly several times.
5.
Replace fill screw.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido