Preparing For Vacation; Preparing To Move; Replacing The Light Bulbs - Crosley XSS23G Manual Del Propietario E Instrucciones De Instalación

Refrigeradores de dos puertas
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and Cleaning

Preparing for Vacation

For long vacations or absences, remove food and
unplug the refrigerator . Clean the interior with a baking
soda solution of one tablespoon (15 ml) of baking soda
to one quart (1 liter) of water . Leave the doors open .
Set the icemaker power switch to the OFF position and
shut off the water supply to the refrigerator .

Preparing to Move

Secure all loose items such as shelves and drawers by
taping them securely in place to prevent damage .
When using a hand truck to move the refrigerator, do not
rest the front or back of the refrigerator against the hand
truck . This could damage the refrigerator . Handle only
from the sides of the refrigerator .

Replacing the Light Bulbs

WARNING
Before replacing a burned-out light bulb, the refrigerator should be unplugged in order to avoid
contact with a live wire filament . (A burned-out light bulb may break when being replaced .)
Turning the control to the OFF position does not remove power to the light circuit .
Refrigerator Compartment—Upper Light
1 . Unplug the refrigerator .
2 . The bulbs are located at the top of the compartment,
inside the light shield . On some models, a screw at
the front of the light shield will have to be removed .
On other models, the screw is located in the pocket
located at the back of the shield .
3 . To remove the light shield, on some models, press
in on the tabs on the sides of the shield and slide
forward and out . On other models, just slide the
shield forward and out .
Your light shield will look like one of the following:
Tabs
4 . After replacing the bulb with an appliance bulb of the
same or lower wattage, replace the light shield and
screw . When replacing the light shield, make sure
that the tabs at the back of the shield fit into the slots
at the back of the light shield housing .
5 . Plug the refrigerator back in .
49-1000105 Rev. 0
OR
Pocket
If the temperature can drop below freezing, have a
qualified servicer drain the water supply system (on
some models) to prevent serious property damage due
to flooding .
Be sure the refrigerator stays in an upright position
during moving .
WARNING
Before replacing a burned-out light
bulb, the refrigerator should be unplugged in order to
avoid contact with a live wire filament . (A burned-out
light bulb may break when being replaced .)
Turning the control to the OFF position does not remove
power to the light circuit .
Refrigerator Compartment—Lower Light
This light is located above the top drawer .
1 . Unplug the refrigerator .
2 . Lift the light shield up and pull it out .
3 . After replacing the bulb with an appliance bulb of the
same or lower wattage, replace the shield .
4 . Plug the refrigerator back in .
15

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Xss25g

Tabla de contenido