Additional Safety Instructions; Use And Operation - Asist AE1KB130DM Instrucciones De Uso

ADDITIONAL SAFETY INSTRUCTIONS

Please read these safety instructions before use and
keep them in a safe place.
! - This symbol indicates the risk of injury or damage
to the device.
! Failure to follow the instructions in this manual may
result in injury.
! The electro-pneumatic hammer drill complies with the
applicable technical regulations and standards.
Always use the auxiliary handle (3) when working with
these tools.
! When using el. Always wear safety goggles
according to accessories. standards or other suitable
eye protection /e.g. the protective shield/. Wear a dust
mask or respirator in areas where dust is generated.
Goggles or other eye protection will bounce off
fragments of material that could endanger your face
or eyes. Blowing dust or gases released by drilled
material (eg asbestos-insulated pipes, radon) can
cause breathing difficulties.
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION (A)
Pneumatic demolition hammer can be used for
crushing asphalt and concrete, grooving, working,
compaction of sand and gravel, digging soil in various
substrates, etc. The machine has a motor for single-
phase alternating current 230 V, 50 Hz. Its compact
and powerful design allows for universal and efficient
use.
1 Power switch
2 Clamping sleeve
3 Front cover
4 Gear lubricant box
5 Power switch
6 Handle
7 Additional handle
8 Gear lubrication hole cover
9 Gear lubricant
10 Hex key
11 Chisel set - flat and pointed
12 Carbons
Accessories
1 handle
1 pointed chisel 18x320mm
1 flat flat chisel 18x320mm
1 pair of carbons
1pc lubricant
1 key
Pictograms
Pictograms on the product packaging:
a) Power supply values
b) Power consumption
c) The energy of a single blow

USE AND OPERATION

ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of an
agreement between the manufacturer and the custo-
mer.
! When working with tools, it is necessary to observe
work breaks.
The time interval between work and break depends on
the complexity of the work, the load on the machine
and the hardness of the material. In general, the har-
der the material, the shorter the work cycles and the
longer work breaks.
! Failure to observe work breaks can lead to irreversi-
ble damage to the tool.
! Always make sure that there is enough lubricant in
the transmission before use.
Before starting work, always check the work area for
hidden electrical cables, gas and water pipes. Use a
metal detector, for example.
Always use the correct supply voltage!
The power supply specification on the identification
plate must correspond to the mains supply voltage.
The chisel must always be firmly seated in the chuck.
The power cord must be routed from the back of the
tool and far enough away from the chisel.
Always use the auxiliary handle (7) when working with
this tool.
Always hold the tool firmly and stand in a stable po-
sition.
If the force exerted on the tool is too great, it will have a
negative effect on the efficiency and service life of the
pneumatic demolition hammer and chisels.
If the chisel blade is blunt, it is necessary to sharpen it
in time, or replace the chisel with a new one. Otherwi-
se, the cutting efficiency will be reduced and the tool
may be damaged.
Switching the device on / off (B)
Hold the hammer with both hands, press the switch
(1). Release the power switch when turning off.
The hammer can be switched to continuous operati-
on by pressing the lock button (5) while pressing the
switch (1). Then release the switch (1). To switch off
continuous operation, press the switch (1) again.
41