HyLoft Heavy Duty Tire Loft Instrucciones De Montaje página 6

2
2A Attach 2 Rubber Wall Glides (H)
to bottom back of both Side
Frames (A).
3
Insert 1" Tube (E) inside 1¼" Tube (F) and fasten using Hex Bolts (D) & Washers (G) through Side Frame (A).
Start with the back and place at the appropriate height to protect wall from tire rub. Location is determined
by tire sizes and can be adjusted to accommodate many sizes.
Insert remaining 1" Tubes (E) into 1 ¼" Tubes (F) and fasten using Bolts (D) & Washers (G) through Side
Frame (A). Locate these tubes to accommodate your desired tire size. Tighten all Bolts (D) using a 9/16"
(14 mm) nut driver or socket wrench.
Adjust width before adding your tires, and place Set Pins (I) in holes on top of Master Rail in desired location.
to keep the tire rack from over adjusting in width. This multi-tire rack is designed for a maximum inside
opening of 58".
Adhere Hyloft Sticker for convenient access to contact information.
Each Tire Loft can hold a maximum of 400 lbs (181 kg). Be sure to distribute the load evenly
Do not over extend the inside opening beyond 58".
Verify all connections at least once per year in order to ensure that they are fastened securely.
ATTACHING THE SIDE FRAMES
2B
INSTALLING THE SHELF TUBES
Adjust width
for tires
Adjust width
for tires
Slide bracket on top back of Side Frames (A) into ends
of Master Rail (B) until they are the distance
apart needed for tire storage. This can be adjusted
later at any time.
HyLoft Sticker