Hayward Powerline PowerSharkII Manual Del Usuario página 25

Remove the cleaner by placing the carton down and removing
1. Select the nearest 230 V
.
insulation
2. Place the power supply so that it is at a minimum distance of 3.5
length of the standard cable is 16.76 meters.
Hayward.
diagnostics routine for several minutes before starting the cleaning cycle.
Caution: DO NOT switch power supply "ON"
damage to the pump and drive motor seals, which will VOID the warranty.
cleaning cycle. If your pool is cleaned in less time than 90 minutes, you may shut the cleaner off
manually by switching the power supply to the off position.
Should a second cleaning cycle be required, switch OFF the power supply for 10 seconds and
restart. (see Power Supply operating instructions)
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
GENERAL OPERATING INSTRUCTION
outlet that is close and protected from short-circuits. Fit a 30 mA differential
Use of non genuine Hayward manufactured parts will void all warranty.
Fig. 2
3.5 m
Fig. 1