Aqua Medic S Manual De Instrucciones página 7

1. Technical Information
multi reactor
Measurements (l x w x h)
Volume
Voltage
Power consumption
Pump ratings
Aquarium sizes
2. Set-Up and Operation
Picture 1: 1. Holding unit 2. Turning knob (flow regulator) 4. O-rings 6. Outlets
If the sponge (3) is dirty and needs to be cleaned, shut-off the pump, open the filter body and
clean the sponge with water.
Our multi reactors S and M are designed to operate either directly inside the aquarium or inside
the filter sump. With the supplied holding unit, the multi reactor can be mounted horizontally on
the aquarium glass. The pump needs to be fully submerged to prevent air suction. The entire body
can be submerged up to the outlets (6) on top of the unit. The immersion depth of the unit can be
adjusted by opening the clamp screw.
When filling the unit, pull on the handle, attached to the inner tube, all the way out of the outer
tube.
7
S (200)
approx. 60 x 50 x 300 mm /
2.5 x 2 x 11.8 in
approx. 150 ml / 5 oz
220 - 240 V / 50 - 60 Hz
2.5 W
approx. 200 l/h / 50 gph
up to 350 ltr / 90 gal
M (350)
approx. 80 x 60 x 420 mm /
3 x 2.5 x 16.5 in
approx. 350 ml / 12 oz
220 - 240 V / 50 - 60 Hz
8 W
approx. 350 l/h / 90 gph
up to 500 l / 130 gal