Royalty Line DB-2200.376.12 Manual De Instrucciones página 17

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 35
Simple Repair Methods:
Problem
Not enough
heator too
much heat
Leakage or
no steam
No steam
burst or no
vertical steam
Water leaking
from sole plate
Too little steam
Not spraying
Possible Reasons
Rotating thermostat dial
incorrectly or the iron
is unplugged
The thermostat dial
has been set to MIN
The steam burst function
has been used too often
within a very hort period.
The iron is not hot enough.
Set the thermostat dial
outside the steam range.
The iron is not hot enough.
The water is over the max
position.
Check that the steam
selector is in the
correct location.
Steam hole is blocked.
Too little water in
the water reservoir.
No enough thumb pressure.
Air trapped inside.
Measurement
Correct Thermostat dial
in position and check if
the iron is plugged.
Set the thermostat dial
to the required position.
Continue ironing in
horizontal position and
wait a while before using
the (vertical) burst of
steam function again
Set the thermostat dial
as per steam range.
Open steam button only
after the indicator light
goes off.
Pour out the remaining
water
Set the steam selector
to the proper location.
Clean hole with distilled
water.
Fill water into the box
Press the spray nozzle
with your hand and push
the spray button several
times continuously.

Publicidad

Tabla de contenido
loading

Tabla de contenido