Slave Mode; System Options; Restore Factory Settings - American Pro STROBOTEC 2 Manual Del Usuario

Working mode 4: "7-ch"
Sheet 10 DMX Mode Function Sheet of CH7
CHANNEL VALUE
1
2
3 0-255
4
5
0-39
40-59
60-79
80-99
6 100-159
160-179
180-199
200-219
220-255
7 0-255

5. Slave Mode

Press the "MODE", the LED display will show "SLAv", enter LED slave mode.
B. System Options
In any state, long press the "SETUP", enter the main interface of the system options: "67A1"
Lightly press the "SETUP", select the temperature protection switch options, PCB temperature inquires, LED biggest
gray, restore factory settings.
Setting details as below sheet:
Temperature control switch options
PCB temperature options
LED biggest gray value
Restore factory setting
On system options, lightly press the "MODE", return to the system main interface "67A1" , press the "MODE" again,
return before LED mode menu.
C. Restore Factory Settings
There are two kinds of methods to restore factory settings.
1) In menu system options "-ES-" , press the "UP" to restore factory settings.
2) When in power failure situation, press the "MODE" and "SETUP", power on to restore factory settings.
PAG. 4
Built-in programs, strobe or speed, sound active/sound active sensitivity
7-on Press UP, will show "7-on", open temperature control.
roff Press DOWN, will show "roff", closed temperature.
7-33 Press DOWN or UP to update temperature, current is 33ºC
L150 Press DOWN or UP update the LED newest brightness (0—255).
-ES-
FUNCTION
Part 1 (bottom-right)
Part 2 (bottom-left)
Part 3 (upper-right)
Part 4 (upper-left)
Master Dimming
NO USE
Built-in program 1
Built-in program 2
Built-in program 3
NO USE
Sound Active 1
Sound Active 2
Sound Active 3
Sound Active 4
Press UP to restore factory settings