Publicidad
1.5 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors
(SATAII_1 (PORT 1): see p.2, No. 13)
(SATAII_2 (PORT 2): see p.2, No. 12)
(SATAII_3 (PORT 5): see p.2, No. 10)
(SATAII_4 (PORT 6): see p.2, No. 7)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 17)
(9-pin USB8_9)
(see p.2 No. 16)
10
ASRock 960GM-VGS3 FX / 960GM-VS3 FX Motherboard
These four Serial ATA2 (SATA2)
connectors support SATA data
cables for internal storage
devices. The current SATA2
interface allows up to 3.0 Gb/s
data transfer rate.
SATAII_1 (PORT 1)
Either end of the SATA data
cable can be connected to the
SATA2 hard disk or the SATA2
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
Publicidad
