Display Settings; Alarm Settings - AO Smith AO-WH-SOFT-450T El Manual Del Proprietario

STEP 10 Setting the Controller
1. On the home screen, press the "MENU" button.
2. On the Main Menu screen, press the button for "Hardness".
3. On the Water Hardness screen, press the "+" button to increase hardness or "-" button
to decrease hardness. Input the compensated hardness determined by your water test.
4. Press the "SAVE" button to save the value and return to the Main Menu screen.
5. Press the "BACK" button to return to the home screen.
The Main Menu screen has other options if you choose to change the factory default settings.
Depending on the model, not all options will apply. The controller should only display options
available to the model for which it is programmed.
Main Menu

DISPLAY SETTINGS

UNITS: Select English or Metric.
TIME: Set the current time of day.
REGEN TIME: Set the regeneration time, if using the Delayed Mode.
REGENERATION SETTINGS
Choose the settings best for your household.
TYPE:
High Capacity - Softener will regenerate less often, but will use more salt.
High Efficiency - Softener will regenerate more often using more water, but less salt.
This is the default. This setting meets or exceeds the requirement some states have for
efficiency.
Automatic - Uses the average daily water usage to determine salt usage and
regeneration cycles. Recommended for large households or those with high levels of
water hardness.
MODE:
Demand - Triggers a regeneration as soon as softening capacity is exhausted. This is
the default.
Delayed - Allows regeneration at a specific time (ex. 2 A.M. when less water is typically
being used).

ALARM SETTINGS

LOW SALT: Select On or Off.
LOW TEMPERATURE: Select On or Off.
WATER USAGE: Toggle between On and Off.
NEED HELP? GIVE US A CALL 855.424.9892
INSTALLATION 15