Makita EY402MP Manual De Instrucciones página 12

NOTICE:
Never toss or drop the tool.
NOTICE:
Do not cover the vents of the tool.
NOTICE:
Do not force the tool. Otherwise, it may
damage the tool.
Stand on a stable surface, and hold the tool away from
the branches so that the angle of the tool becomes 60°
or less against the horizontal ground.
► 1. 60° or less
Start the tool, and then press the saw chain onto the
branch lightly.
When cutting long branches, in order to control the drop
position of cut branches, divide the branch in sections
and cut the branch from the tip. Pay attention to the
falling branches since they may bounce in the direction
of the operator after hitting the ground.
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
1
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
If you try to cut off thick branches from the top without a
shallow undercut, the branch may splinter.
1
Carrying tool
Before carrying the tool, always remove the battery
cartridge or the spark plug cap, and then attach the
guide bar cover. Also cover the battery cartridge with
the battery cover.
► 1. Guide bar cover 2. Battery cover
MAINTENANCE
CAUTION:
switched off and the battery cartridge or the spark
plug cap is removed before attempting to perform
inspection or maintenance.
CAUTION:
ing any inspection or maintenance.
2
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
12 ENGLISH
1
Always be sure that the motor is
Always wear gloves when perform-
Never use gasoline, benzine, thinner,
2