Southland SCS2052.1 Manual Del Operador página 21

Maintenance
• Save these instructions
D
Engine Care
Refer to the separate Engine Owner's Manual for engine Maintenance.
•
E
Cleaning the Impeller Housing (Fig. 6)
The impeller's shredder blade and
chipper blades are sharp. Wear leather
work gloves to protect your hands when
cleaning out the impeller housing.
If the impeller housing becomes clogged with
debris, the shredder grate can be pivoted
upward to clean the surrounding area.
To do so, proceed as follows:
1. Stop engine, disconnect spark plug
and wait for chipper shredder to come
to a complete stop.
2. Remove debris bag. Refer to
Emptying Debris Bag paragraph
under Operation for correct
procedure.
3. Loosen the two wing knobs (9) on
either side of the chute deflector (10)
and pivot the chute deflector upward.
4. Remove the hairpin (22) from the
clevis pin (23) which extends through
the housing and shredder grate.
Remove the clevis pin.
Questions? Call Toll Free at 1-800-737-2112
10
12
23
22
Figure 6A
9
5. Pivot the shredder grate (24) upward.
Clean the surrounding area by
scraping away debris.
6. When the area is cleaned, pivot the
shredder grate downward and secure
with the clevis pin (23) and hairpin (22)
removed earlier.
7. Verify that the spark plug wire is
disconnected and away from spark
plug. Pull on the starter rope two-to-
three times to purge any remaining
debris from the impeller housing.
8. Tighten wing knobs (9) and reattach
the debris collection bag to the
chute deflector. Refer to Debris
Bag paragraph under Assembly for
correct procedure.
9. Install spark plug wire to spark plug
when ready to continue using the
machine.
ENG - 21
Copyright © 2015 MAT Engine Technologies, LLC
24
Figure 6B