Installing The Batteries; Battery Precautions; Remote Control Range - Sylvania 6842THG Manual Del Propietário

ANT. IN jack
Connect your antenna or cable
box here.
DIGITAL AUDIO OUT
(COAXIAL) jack
Connect an optional coaxial
digital audio cable here through
the coaxial digital audio in jack
of a decoder or audio receiver.
VIDEO2 IN jacks
R
Connect video
AUDIO
cable or S-video
L
cable and audio
cable coming from
VIDEO2
the video or
S-VIDEO2
S-video and audio
out jack of exter-
by side
nal devices.
COMPONENT IN jacks
Connect component cable
and audio cable coming from
the component and audio out
jack of external devices.

INSTALLING THE BATTERIES

Install two AA batteries (supplied) matching the polarity indicated inside battery compartment of the remote
control.

[BATTERY PRECAUTIONS]

• Be sure to follow the correct polarity as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
• Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old batteries with fresh ones.
• If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
• Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.

REMOTE CONTROL RANGE

Operate the remote control within a 30 degree angle on both sides of the infrared sensor on the main unit.
You can operate the remote control from a distance of several yards away from the main unit.
Within 30 degrees
Approximately 5.5 yds (5 m)
ANT. IN
AUDIO OUT
L
DIGITAL
AUDIO OUT
R
(COAXIAL)
Rear of this TV
ANT. IN HDMI
AUDIO OUT AUDIO
L L
DIGITAL HDMI IN
AUDIO OUT
(COAXIAL) R R
COMPONENT2 COMPONENT1
Y Y
L L
Pb Pb
AUDIO AUDIO
R R
Pr Pr
Within 30 degrees
Approximately 5.5 yds (5 m)
Approximately
7.6 yds (7 m)
AUDIO OUT jacks
Connect the supplied audio
from underneath
cable here through the audio
in jacks of audio equipment.
HDMI
AUDIO
HDMI IN jacks
L
Connect HDMI cable and
HDMI IN
R audio cable coming from the
HDMI and audio out jack of
external devices.
COMPONENT2 COMPONENT1
AC IN
Y Y VIDEO1
L L L
Pb Pb
AUDIO AUDIO AUDIO
R R R
Pr Pr S-VIDEO1
VIDEO1
L
AUDIO
R
from underneath
NOTE:
Other devices which use infrared beams, sun-
light, fluorescent lights, etc., may affect the
range and effectiveness of the remote control.
Make sure the TV is positioned in a place which
minimizes interference from them.
VIDEO1 IN
jacks
Connect video
cable or
S-video cable
and audio
cable coming
from the video
or S-video
and audio out
S-VIDEO1
jack of exter-
nal devices.
EN
7