KEUCO 16830 519000 Manual De Instrucciones De Uso página 4

EN
These instructions are designed for the installation engi-
neer to assemble the product and for the user to operate
and maintain it. After installation, please pass them on to
the user for safekeeping.
Symbols and their meaning
Caution! Warning of personal injury or material
damage.
Caution! Warning of electric shock.
Caution! Warning of water damage.
Note, tip or reference
Incorrect assembly
Correct assembly/functional test
Observe assembly details
Optional/accessories
Safety Information
– The electrical installations must be undertaken by a
specialist electrical installer in compliance with IEC
60364-7-701/VDE 0100 Part 701! National and local
regulations must be taken into consideration!
– Do not start the appliance if it or the power supply ca-
ble is damaged, but have it replaced by the manufac-
turer, its customer service or by an equally qualifi ed
person.
– Do not look directly into the active light source!
Intended use
Shower light for use in bathroom and toilet.
This shower light is SwitchDim-controllable and must be
connected accordingly. The SwitchDim concept is based
on DSI technology (Display Serial Interface). Instead of
using a DSI control device, which sends a digital signal
to the light, the mains frequency is used as signal gene-
rator.
The product is suitable only for mounting indoors!
Caution! Only install in frost-free rooms.
Declaration of conformity! This product complies with
the requirements of the valid EU Guidelines. The dec-
laration of conformity for this product can be requested
from the following address:
KEUCO GmbH & Co. KG, Oesestraße 36,
D-58675 Hemer.
4
Important information, please read!
Technical data
Mounting dimensions, see page 2.
Installation, see fi gure 1 onwards on page 12.
Connection (NYM-J 5x1.5 / 7.1-10 mm), refer to fi gure 10 on
page 13.
Operation
S1 S2
Replacement parts with order numbers, see page 15.
– Flow at 3 bar pressure:
– Supply voltage:
– Max. power consumption:
– Protection category:
– Ambient conditions
Temperature:
– Luminous colour:
– Lighting current:
L
= brown
N
= blue
= green/yellow
L1
= grey
L2
= black
S1 S2
The light is operated via an external 2-function switch.
Use only momentary contact switches, not regular
switches.
Momentary contact switches make switch contact as
long as they are pressed, but regular switches remain
in the position they are switched to even after being
released.
S1 short On / Off
Continuously increase / reduce bright-
S1 long
ness value
Adjust colour temperature in steps from
S2 short
6500 to 2700 kelvin
Adjust colour temperature continuously
S2 long
from 6500 to 2700 kelvin
The light sources may only be replaced by the
manufacturer, its customer service or by an equally
qualifi ed person.
For information about warranty and maintenance, see
the enclosed Care Instructions and Warranty Card.
Disposal information! Equipment with this labelling
must not be disposed of in household refuse, but must
be disposed of at a collection centre intended for this
purpose.
max. 15 l/min
220V-240V AC / 50Hz/60Hz
12 W
IP65
5° – 40° C
2700 – 6500 Kelvin
1300 lm
L1
L2
L
N