Before First Use; Installing The Condensation Collector - bene casa BC-99210 Manual De Usuario Y Guía De Recetas

BEFORE FIRST USE

Remove all accessories and read this manual carefully. Please pay particular attention
to operational instructions and cautions to avoid any injury or property damage.
1. Wash the inside of the lid and the inner pot with warm soapy water, rinse and dry
thoroughly. Make sure water is fully drained after washing.
2. Clean the outside of the cooker base with a clean damp cloth.
1 1
CAUTION: Never immerse the cooker base in water or any
other liquid or clean in the dishwasher.

INSTALLING THE CONDENSATION COLLECTOR

To install the condensation collector, slide it into the slot on the cooker base. Follow the
reverse order to remove it for cleaning.
8
2
REMOVING AND REINSTALLING THE ANTI-BLOCK SHIELD
The anti-block shield can be removed by pushing it on the side and outward. To install the anti-block
shield, position it in place and press it down.
REMOVING AND INSTALLING THE SEALING RING
The sealing ring can be removed by pulling it outward, section by section, from the sealing ring rack. To
reinstall the sealing ring, press it down into the rack section by section. The sealing ring can be installed
with either side facing up.
PLEASE NOTE THE FOLLOWING:
• Prior to each use, inspect to make sure the sealing ring is well seated in the sealing ring rack and the
anti-block shield is mounted properly on the pressure release valve. A properly seated sealing ring
can be shifted, with a bit of effort, clockwise or counterclockwise inside the sealing ring rack.
• After use, remove any food debris from the sealing ring and anti-block shield.
• Condensation collector cup should be cleaned with warm, spay water after each use.
• Keep the sealing ring clean to avoid odor. Washing the sealing ring in warm soapy water or
dishwasher can remove odor. However, it is normal for the sealing ring to absorb the smell of certain
acidic foods.
• Never pull the sealing ring by force, as the force may deform the sealing ring and ring rack and affect
the pressure sealing function.
• A sealing ring with cracks, cuts, or other damages should be replaced immediately.
9