WARNING:
Start Using Your Cooker Hood
Touch control with LED display
1. Press the "Power" button, the button control the "on" & "off " of the hood.
2. Press the button "Speed" time after time, the motor runs as low / mid / high / low
/ mid..., the speed runs circularly; and the LED display will indicate as 1-2-3-1-2...
circularly.
3. Press "Light" button, the light is on, press this button again, the light is off.
Please note the Lamp is not under control of the on/off button.
4. When the hood is working, if press the "Timer" button, the hood will go into the
status of acquiescent working (acquiescent time is 9mins), and then, LED display
will be shown 9.8.7.6 ...decreasing by 1, when time is up, the hood will be off
automatically and the lamp will extinguish. If pressing "Timer" button, the hood will
go in or go out "Timer" function.
TROUBLESHOOTING
Fault
Light on, but motor
does not work
For safety reason, please use only the same
size of fixing or mounting screw which are
recommended in this instruction manual.
Failure to install the screws or fixing device in
accordance with these instructions may result in
electrical hazards.
Possible Cause
Fan switch turned off
Fan switch failed
Motor failed
Select a fan switch position.
Contact service center.
Contact service center.
20
Solution