Lite-Ex Pl 30E Components; Getting Started; Battery Replacement - Ecom Lite-Ex PL 30e Instrucciones De Uso

8.1. Lite-Ex PL 30e components

Body of torch
Sealing rings
30x2
Twist ring
35x2
39x1,5
Battery compartment
Housing head
Alignment screw
Torch head
Spare disc
Illustration 1

8.2. Getting started

In order to be able to use the torch in the Ex-area, you must first check
that the outer housing head and body are screwed on completely. After this
has been done, you can switch on the torch by turning the yellow twist ring
slightly in a clockwise direction. The enclosed batteries have to be inserted
first in the device (see section 8.3).

8.3. Battery replacement

When the brightness is no longer satisfactory, the batteries should be
replaced. It is strongly recommended that all three batteries are be replaced
together. When replacing the batteries, only use approved battery types
(see table of approved battery types in section 7: Technical data).
To replace the batteries, hold on to the housing head and the twist ring,
and turn the body of the torch anticlockwise until it comes off. Take the
used batteries out of the battery compartment, observing correct polarity
and replace them with new ones. After you have inserted the new batteries
screw the body of the torch back on. Make sure that torch components are
screwed together securely before switching the torch on.
8