Voice Setting - Medicura m246 Folleto De Instrucciones

You can turn off the monitor by pressing "START" button when the minute is blinking, then the
time and date is confirmed.
The monitor will turn off automatically after 1 minute of no operation with the time and date
unchanged.
Once you change the batteries, you should readjust the time and date.

VOICE SETTING

Switch the monitor on by using the touch button switch (ON position).
Voice language setting: In clock mode, you can select the voice language by
keeping on press the button "MEM". Now LCD blink "L0", "L1", "L2" ... "Ln"
(n means the number of language) circularly. "L0" represents closing voice
function, "L1" represents language 1, "L2" represents language 2,...,"Ln"
represents language n, and so on. You can select the wanted language by
releasing button "MEM" when display the corresponding language code.
If the number of language is only one, LCD will twinkle "ON" and "--" circularly.
Here "ON" represents opening the voice function and "--" represents closing
the voice function.
Voice volume setting: Once you have selected a language, keeping on
pressing the button "MEM" again. A column of bar will appear on the left side
of the LCD. The higher the bars, the louder the volume. Release button "MEM"
at your desirable volume for confirmation.
Switch the monitor on by using the touch button switch (ON position).
After applying the cuff and your body is in a comfortable position, press the
"START" button. A beep is heard and all display characters are shown for
self-test. You can check the LCD display according to the right picture. Please
contact the service center if segment is missing.
If the monitor has stored results, the LCD will momentarily display the most
recent one. If no result has been stored, zero will appear on LCD.
If the voice function is switched on, the monitor will speak out measurement
tips.