Setting The Dip Switches - AERMEC VMF-E3 Manual De Uso Y Instalación

4. OPENING AND CLOSING THE PANEL FOR INSTALLATION AND SETTING
1
On the lower part of the panel there
are two hooks that must be pressed
with the aid of a flat screwdriver.
NOTES FOR INSTALLATION:
1. The VMF-E3 is a control panel for wall installation. It can be fixed directly to the wall itself (using suitable screws - NOT SUPPLIED - to attach the rear body), or on top
of a 502 flush-mounting box.
2. However you want to fix the VMF-E3 panel to the wall, make sure the cables for the connections are positioned so they don't hamper installation operations and
possible maintenance (for more information about the electrical connections, refer to the specific section of this manual).
3. The rear body to be fixed to the wall MUST be positioned respecting the references (UP-DOWN) printed on it - i.e. with the "UP" side facing upwards.
5.

SETTING THE DIP SWITCHES

Dip 1 Dip 2
OFF OFF
OFF ON
ON OFF
ON ON
Dip switch Status
ON
Dip 3
OFF
ON
Dip 4
OFF
2
Once the lower restraints have been
released, remove the body and board
by rotating them outwards.
Selectors (mode and setpoint) not active; in this case, the value of the selectors is "saved" and used without the possibility
The LEDs switch off when the mode/setpoint selectors are left unused for 30 seconds
3
The board is attached to the body
by means of pressure; to remove it,
press lightly on the upper or lower
edge of the body and push the front
selectors to detach the board from
the protective plastic.
Meaning
Use the probe on the VMF-E3 panel
Use the probe connected to the thermostat
The average of the probes
Function not used
Meaning
to be modified via the selectors themselves
Selectors (mode and setpoint) active
The LEDs are always active
4
The board has dip switches that must
be set according to the specific re-
quirements (for more information,
refer to the specific section of this
manual). Once the dip switches have
been configured, the panel can be
put back in place (following the
above steps in reverse order).