Installing Your Phone - MaxWest MX-D100 Manual Del Usuario

Install the SIM and Battery:
Ÿ
Slide out the battery compartment cover.
Ÿ
Insert the SIM card with correct direction in the
SIM tray in battery compartment (Refer Figure
2).
Ÿ
Insert the supplied 3.7V Li-ion battery in to the
battery connector in battery compartment (Refer
Figure 2).
Ÿ
Slide the battery compartment cover back.
Connect the Phone:
Ÿ
Connect the handset with base unit by using coil cord (Refer Figure 1).
Ÿ
Plug the switching adaptor in to the Mini USB DC 5V port on the base rear side (Refer
Figure 3).
Ÿ
Charge the battery for 6-8 hrs. before initial use.
Ÿ
Press and hold the "Power ON/OFF"key to switch "ON" the Fixed Wireless Phone.
Ÿ
After that service provider name will appear on the LCD display which indicates that now
your phone is ready to receive and make calls. (If signal strength is very poor at the
location of phone and "Emergency" appears on the LCD display then it is recommended
to install the phone at some other location where there is better signal strength).
Set the time and date manually:
Ÿ
For setting the time and date on LCD display refer page
Insert SIM here
with correct
direction

INSTALLING YOUR PHONE

SIM Tray
Battery
Connector
Connect 3.7V
Li-ion Battery
Connect Switching
connector here
Adaptor Here
Figure 2
Fixed Antenna
Battery
Cover
Figure 1
Figure 3
Coil
Cable
Jack
Mini USB
DC 5V
Port
Figure 4