Intellinet 508261 Instrucciones página 3

8-Port Gigabit Ethernet PoE+ Industrial Switch with 2 SFP Ports
Power
Terminal Block Installation
NOTE: Ensure all power is off/disconnected before beginning!
1 Loosen appropriate screws.
2 Insert bare power-supply wires into appropriate terminal slots (positive
wire into positive slot; negative wire into negative slot).
3 Tighten appropriate screws to secure wires. (If desired,
repeat steps 1 – 3 on second input pair.)
4 Install block into the device and tighten screws.
1
Placement
Desktop Installation
Prior to use, place/position the switch:
• on a level surface with at least 25 mm (approx. 1") of clearance for ventilation
• away from sources of electrical noise: radios, transmitters, broadband amplifiers
within 100 m (approx. 328') of network devices it's to be connected to.
DIN-Rail Installation
1 With DIN-rail bracket attached to device with screws, angle bracket onto DIN rail.
2 Push device in till it clicks into place.
2
1
Instructions
3
2
4
3
English