Yakima Q Stretch Kit Manual De Instrucciones página 2

fIrsT TIme
Q-Tower InsTallaTIon:
install the front towers
(Q-tower instructions)
and continue below.
ON A NeW INsTAllATION, DIsAsseMble The TWO ReAR TOWeRs.
CAm
CoveR
Adjustment
Post
AsseMble ReAR clIPs.
insert the correct clip
into the rear clip holders.
find the measurement for your car
wITh a Q-sTreTch KIT.
• find your car's m3 in the clip sheet, or at yakima.com.
• Position towers at the new m3 distance, measuring
from inboard tower edges.
On a flat surface...
3 3
M M
1. Completely tighten first tower screw.
2. Apply firm downward pressure to
crossbar and tighten second tower.
1033431C - /15
• open the cam cover.
• Completely unscrew the adjustment post.
• Carefully lift out the clip holder assembly, and set aside.
CliP
holdeR
Assembly
insert lock housing through
clip, matching the notches.
After tightening
both towers,
measure again to
be sure the towers
have not moved.
conTInUe To sTeP 10
• insert fastener and push it down
over lock housing.
• do not instAll loCks yet.
then snap towers closed.
If Q-Towers
are already
InsTalled
GO TO sTeP 6.
3
M
When using the
wrench, insert the
short end, hold the
long seCtion.
"snAP"