ENFORCER SS-072Q Manual De Instrucciones

SS-072Q / SS-073Q
Tamper Switch
Installation:
Please read manual before the installation.
IMPORTANT: When mounting the tamper switch, keep in mind that the switch must be depressed at least
1. Decide the appropriate position for the SS-072Q / SS-073Q.
NOTE: The switch must be positioned so that it will be depressed at least
2. Drill the three holes necessary for the SS-072Q / SS-073Q to be mounted firmly in place. The diameter of the hole is
selected according to your personal preference and need.
3. Connect the wires to the switch terminals using series circuitry, see Fig.1.
Overview:
Fig.1 – Used inside cabinet or drawer when cabinet
or drawer is pulled open
1 / " (6mm) Minimum activation distance
4
Drill three holes, each hole
(3mm) and insert screws
Connect the wires to switch
terminals using series circuitry
To alarm system
Inside of Alarm Case
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for one (1) year from the date of sale to the original customer.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also
not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All rights reserved.
®
SECO-LARM
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com
Manual
Type: S
49J5
Fig. 2- Case against wall.
Use two SS-072Q or SS-073Q to
protect against the forced removal of
the case from the wall and the forced
removal of the case's cover or lid
/ "
1
To alarm
8
system
Case
cover/lid
Website: www.seco-larm.com
Features:
• Used in alarm systems with normally-closed or normally-open circuits
• Silver-plated contact ensures reliability and long-term operation
• Small size makes it easy to hide and install
• UL Listed for supplementary protection
Specifications:
Model
Plunger pushed in
Plunger released
Contact rating
Enclosure
Dimensions
Weight
/ " (6mm) to activate.
1
4
Case body
Hole must be
made for the
tamper switch
to fit through
Wall
SS-072Q
Contact closed
Contact open
0.5A@24VDC
High-impact plastic resin
2 / "x1 / "x / " (70x28x16 mm)
3 1 5
4 16 8
0.6-oz (18g)
/ " (6mm) distance in order to activate the switch.
1
4
/ " (3mm). Screws should be
1
8
Fig. 3 – Used inside box when top is opened
upward or lifted off
Case
cover/lid
To alarm
system
SS-073Q
PITSW1
Order Part# 763-041-3%
MI_SS-07xQ_190208_ML.docx