Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
ASSEMBLE THE SHREDDER STAND
1.
Loosen the leg height adjustment knob, pull the tube to the height you need, then
tighten the knob. (Fig. 6 & 7)
Leg height adjustment knob
Fig.6
Fig.7
2.
Depress the locking pin with finger as shown in Fig. 8, insert the tube into the leg
assembly hole. Let the locking pin slip into the leg assembly hole. Repeat with the
two remaining leg assembly holes.
Fig.8
Fig.9
Locking pin
9
ASSEMBLY
ASSEMBLE THE SHREDDER STAND
1.
Place the motor housing on the stand. Make sure the motor housing is stable on the
legs (Fig. 10).
Fig.10
2.
Fit the funnel onto the motor housing. Let the funnel knotch line up with the motor
housing rib. Make sure it's locked down by the two clamps found on the motor
housing (Fig. 11).
Fig.11
Gap lines up
with rib
Motor housing
rib guide
10
Publicidad
Capítulos
