When Dirty - Mitsubishi Electric MA-E85R-E Manual De Instrucciones

Cleaning
To maintain the performance, perform cleaning regularly.
Timing and Parts to Clean

When dirty

When the Clean Dust
Box lamp lights up
Approximately once
every four months
Approximately once a
month
Approximately once
every six months
When there is an odor
coming out of the air outlet
Turn OFF the operation On/Off switch, disconnect the power
plug, and check that the blower fan is stopped before cleaning.
Do not use detergent, scouring powder, chemically-treated
cleaning cloth, gasoline, benzene, thinner, etc.
This may damage the main unit.
WARNING
When Dirty
Main unit
Wipe with a soft
cloth.
When the unit is very dirty,
wipe it with a damp cloth.
12
l Main unit P.12
l HEPA filter, pre-filter,
and dust box unit
P.12–13
l Dust box P.14
l Sensors
P.14
(odor sensor and
PM2.5 Sensor)
l Lens of PM2.5 Sensor
P.14
l Platinum catalyst and
activated charcoal filter
P.15
Remove the power plug before
cleaning.
Failure to do so may cause electric
shock or injury.
When Dirty
HEPA filter, pre-filter, and
1
Remove the inlet panel,
empty the dust box
and remove the pre-filter unit
2
Clean the HEPA filter.
Suck up the dust with a
vacuum cleaner using a nozzle
with a brush.
3
Remove the dust box unit and pre-
filter.
1 Turn the screw and then remove the dust box
unit.
2 Turn the knobs (4 places) and remove the pre-
filter.
Pre-filter
,
P.14
.
P.8
Screw
Dust box unit
Knobs
(4 places)