Network Configuration - Ebode IPV4NVR Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
6. Remote Access
Assume you need to log in to your NVR from LAN or WAN via the browser. You need to
perform following configurations:
Note: IPV4NVR supports 32-bit IE8 or later versions and does not support 64-bit browsers.

6.1 Network Configuration

1. Configure network information.
Right click the mouse in the live view mode, choose "Menu > Settings > Network". Check
the Network checkbox, configure the network information of the NVR.
Check Network
Check UPNP
It is highly recommended to set the HTTP Port range from 5000 to 65535, and the value of
the HTTP Port No. for each device should be unique.
2. Configure the DDNS.
Right click the mouse in the live view mode, choose "Menu > Settings > Network". Check
the DDNS checkbox. Enable DDNS of the NVR. We recommend you to use the DDNS by
factory default.
1-5-2015
Click Save
- 10 -
Select the Type
Set the HTTP Port
IP Address: Set it
to an IP address
of NVR in the
range of router
address pool, or
keep it as default.
Subnet Mask:
Keep it as default.
Gateway and DNS
Server: Set it to
the IP address of
your router.
ebode IPV4NVR

Publicidad

Tabla de contenido
loading

Tabla de contenido