Blade Attachment - Hinkley 52 METRO ILLUMINATED Manual De Instrucciones

BLADE ATTACHMENT

NOTE:
Remove any rubber supports that are installed for
shipping.
Place Fiber washer on screw. Insert this assembly through
1
the blade and start the screw into the blade arm. Repeat
this procedure without tightening the screw until all 3
screws have been started into the blade arm (Fig. 1).
Tighten each screw starting with center screw.
2
Fasten blade assembly to motor with provided screws and
3
lock lockwashers. Repeat procedure for remaining blades
(Fig. 2). Make sure screws are TIGHT! Loose motor screws
can contribute to unnecessary hum during operation.
NOTE:
Cordless power screwdrivers are NOT recommended, as
they usually strip the heads of the screws and usually will not
fully compress the lock washers on the motor screws. Use a
large flat blade screwdriver for final tightening to fully
compress the washers. This will help ensure proper
alignment of the blades and noise-free, wobble-free running.
Screw
Fiber Washer
Blade Arm
Fig. 1
Screws
Fig. 2
©2020 Hinkley Lighting, Inc. | hinkley.com |
Blade
Blades Assembly
11