Blade Attachment - Hinkley BIMINI 60 Manual De Instrucciones

BLADE ATTACHMENT

Screws
Screws
Rubber
Washers
Blades
Blade Arms
Place rubber washer on screw. Insert this assembly
1
through the blade and start the screw into the blade
arm. Repeat this procedure without tightening the
screw until all 3 screws have been started into the
blade arm.
Tighten each screw starting with center screw.
2
Fasten blade assembly to motor with provided
3
screws and lockwashers. Repeat procedure for
remaining blades. Make sure screws are TIGHT!
Loose motor screws can contribute to unnecessary
hum during operation.
NOTE:
Cordless power screwdrivers are
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
©2019 Hinkley Lighting, Inc. | hinkley.com |
NOT recommended,
11