Allen + Roth 1138-2 Manual Del Usuario página 4

CAUTION
• Assemble on a soft, non-abrasive surface.
• Don't fully fasten the bolts until all bolts are in place.
• Changes or modifications not approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures：
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any part is missing or damaged, do not attempt
to assemble the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly: Allen key (included).
ASSEMBLY INSTRUCTIONS
1. Attach the table legs (B) to the foot ring (D)
with the long bolts (AA) using the Allen key
(GG).
Hardware Used
Long bolt
AA
1
x 4
4
B
AA
D