Vacuum Motor - Mytee HP60 Spyder Instrucciones

ATTACH HOSES
Firmly attach hose and quick disconnect. Make sure quick discon-
nects snap together firmly. Once attached to unit connect Q.D. to
upholstery tool. Always inspect hoses for cracks or fraying.
HEATER
Release tool trigger. Turn on heater. Wait 8 – 10 minutes for unit
to pre-heat. Once heated, re-key upholstery tool until hot water
begins flowing. Once hot water is flowing, release trigger and pre-
heat an additional 4 – 5 minutes.
PUMP
After the machine has been plugged into a 20 amp grounded
outlet, turn on pump. Key tool until upholstery tool releases a
steady flow.

VACUUM MOTOR

Turn on vacuum motor and begin cleaning. For best results
make two dry passes to every wet pass.