UNAcare wheel Mini Manual Del Usuario página 17

Attach the central adapter
3.3.4
1
The following steps should be performed with the user seating in the wheelchair.
2 Insert the short ends of the central adapter's tubes into the clamp's brackets
3 Adjust the width of the assembly if necessary
4
Use the clamps' handles to tighten the brackets and secure the central adapter in
place .
3
3
5
Position the hook of the central adapter 20.5 cm (8") above the ground, at a
vertical angle of approx. 10º. Adjust the height by sliding the hook up or down in
the central adapter or by clamps up or down the frame.
6
Tighten the two front bolts of each clamp. Use a 4 mm Allen wrench.
7 Tighten all 8 bolts of the central adapter.
8 Make sure adaper may be easily inserted and taken out of clamps by user himself.
.
2
2
17
1
Adjust position
of stop rings and
tighten with 2 mm
Allen wrench
20,5 cm
10
O
.
1