Troubleshooting - BLACK&DECKER SC1400 Manual De Instrucciones

90504614 SC1400 Lith Ion drill
Drilling in Metal
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard
oil.
Drilling in Masonry
Use carbide tipped masonry bits. Refer to Drilling section. Keep even force on the drill but
not so much that you crack the brittle material. A smooth, even flow of dust indicates the
proper drilling rate.

Troubleshooting

Problem Possible Cause
• Unit will not start. • Battery not charged.
• Battery will not charge. • Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service organizations, always using identical
replacement parts.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid
by Black & Decker. In some areas, it is illegal to place spent lithium-ion
batteries in the trash or municipal solid waste stream and the RBRC
program provides an environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent lithium-ion
batteries. Help protect our environment and conserve natural resources by
returning the entire tool to an authorized Black & Decker service center for
recycling. You may also contact your local recycling center for information, or call
1-800-8-BATTERY.
6/19/06 9:49 AM Page 9
Possible Solution
• Check battery charging
requirements.
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging
in a lamp or other
appliance.
• Check to see if
receptacle is connected
to a light switch which
turns power off when
you turn out the lights.
• Move charger and
tool to a surrounding
air temperature of
above 40 degrees F
(4,5°C) or below
105 degreesF (+40,5°C)
9