BLACK&DECKER SPITFIRE SP1400D Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

1 1
4 4
. .
4 4
& &
1 1
1 1
4 4
. .
4 4
& &
1 1
INSTRUCTION MANUAL
Catalog Numbers SP1400D, SP1800D
BEFORE RETURNING THIS PRODUCT
FOR ANY REASON PLEASE CALL
1-800-544-6986
IF YOU SHOULD EXPERIENCE A PROBLEM
WITH YOUR BLACK & DECKER PRODUCT,
C C A A L L L L 1 1 - - 8 8 0 0 0 0 - - 5 5 4 4 4 4 - - 6 6 9 9 8 8 6 6
BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No.,
TYPE No., AND DATE CODE. IN MOST CASES, A BLACK & DECKER REPRESENTATIVE CAN
RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT,
GIVE US A CALL. YOUR FEEDBACK IS VITAL TO BLACK & DECKER.
SAVE THIS MANUAL FOR
FUTURE REFERENCE.
VEA EL ESPAÑOL EN LA CONTRAPORTADA.
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y
PÓLIZA DE GARANTÍA. ADVERTENCIA: LÉASE ESTE
INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
Cat #. SP1400D, SP1800D Form # 5146604-01 (SEPT-05)
Copyright © 2005 Black & Decker
GENERAL SAFETY RULES - FOR ALL BATTERY
OPERATED TOOLS
WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed below, may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
Work Area
• Keep your work area clean and well lit. Cluttered benches and dark areas invite
accidents.
• Do not operate power tools in explosive atmospheres, such as in the presence of
flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or
fumes.
• Keep bystanders, children, and visitors away while operating a power tool.
Distractions can cause you to lose control.
Electrical Safety
• Do not abuse the cord. Never use the cord to carry the tool. Keep cord away from
heat, oil, sharp edges or moving parts. Replace damaged cords immediately.
Damaged cords may create a fire.
• A battery operated tool with integral batteries or a separate battery pack must be
recharged only with the specified charger for the battery. A charger that may be
suitable for one type of battery may create a risk of fire when used with another battery.
• Use battery operated tool only with specifically designated battery pack. Use of any
other batteries may create a risk of fire.
Personal Safety
• Stay alert, watch what you are doing and use common sense when operating a power
tool. Do not use tool while tired or under the influence of drugs, alcohol, or
medication. A moment of inattention while operating power tools may result in serious
personal injury.
• Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your
hair, clothing, and gloves away from moving parts. Loose clothing, jewelry, or long hair
can be caught in moving parts. Air vents cover moving parts and should be avoided.
• Avoid accidental starting. Be sure switch is in the locked or off position before
inserting battery pack. Carrying tools with your finger on the switch or inserting the battery
pack into a tool with the switch on invites accidents.
• Remove adjusting keys or wrenches before turning the tool on. A wrench or key that is
left attached to a rotating part of the tool may result in personal injury.
• Do not overreach. Keep proper footing and balance at all times. Proper footing and
balance enables better control of the tool in unexpected situations.
• Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes,
hard hat, or hearing protection must be used for appropriate conditions.
Tool Use and Care
• Use clamps or other practical way to secure and support the workpiece to a stable
platform. Holding the work by hand or against your body is unstable and may lead to loss of
control.
• Do not force tool. Use the correct tool for your application. The correct tool will do the
job better and safer at the rate for which it is designed.
• Do not use tool if switch does not turn it on or off. A tool that cannot be controlled with
the switch is dangerous and must be repaired.
• Disconnect battery pack from tool or place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such
preventative safety measures reduce the risk of starting the tool accidentally.
• Store idle tools out of reach of children and other untrained persons. Tools are
dangerous in the hands of untrained users.
• When battery pack is not in use, keep it away from other metal objects like: paper
clips, coins, keys, nails, screws or other small metal objects that can make a
connection from one terminal to another. Shorting the battery terminals together may
cause sparks, burns, or a fire.
8 8
V V
O O
L L
T T
D D
R R
I I
L L
8 8
V V
O O
L L
T T
D D
R R
I I
L L
Printed in China
• Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools,
with sharp cutting edge are less likely to bind and are easier to control.with sharp.
• Check for misalignment or binding of moving parts, breakage of parts, and any
other condition that may affect the tools operation. If damaged, have the tool
serviced before using. Many accidents are caused by poorly maintained tools.
• Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on
another tool.
Service
L L
S S
• Tool service must be performed only by qualified repair personnel. Service or
L L
S S
maintenance performed by unqualified personnel could result in a risk of injury.
• When servicing a tool, use only identical replacement parts. Follow instructions in
the Maintenance section of this manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of electric shock or injury.
Specific Safety Rules
• Hold tool by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock the operator.
• When working on a ladder or on scaffolding be sure to lay the tool down on its side
when not in use. Some tools with large battery packs will stand upright but may be easily
knocked over.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do this type of work. To
reduce your exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed areas
with soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.
WARNING: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face
and body.
The label on your tool may include the following symbols.
V ..........................volts
Hz ........................hertz
min ........................minutes
......................direct current
.......................... Class II Construction
........................safety alert symbol
Battery Cap Information
Battery storage and carrying caps are provided for use whenever the battery is out of the
tool or charger. Remove cap before placing battery in charger or tool.
WARNING: Do not store or carry battery so that metal objects can contact exposed
battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product
kit boxes, drawers, etc. with loose nails, screws, keys, etc. without battery cap. Transporting
batteries can possibly cause fires if the battery terminals inadvertently come in contact with
conductive materials such as keys, coins, hand tools and the like. The US Department of
Transportation Hazardous Material Regulations (HMR) actually prohibit transporting
batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage)
UNLESS they are properly protected from short circuits. So when transporting individual
batteries, make sure that the battery terminals are protected and well insulated
frommaterials that could contact them and cause a short circuit.
1
3
Depress for reverse (this
side)
Enfoncer pour la marche
arrière
(ce côté)
Oprima para reversa (este
lado)
Trigger Switch
Interrupteur à gâchette
Conmutador tipo gatillo
5
Gear Shifter
Bouton à deux vitesses
d'engrenage
Palanca de cambio
2
1A
4
Depress for forward (other
side)
Enfoncer pour la marche
avant (autre côté)
Oprima para marcha
adelante (otro lado)
Torque Adjust Collar
Collier de réglage de couple
Collar de ajuste de par torsor
6
7
A..........................amperes
W ........................watts
......................alternating current
n o ........................no load speed
........................ earthing terminal
.../min ..................revolutions or
reciprocations per minute
Battery Cap
Capuchon du bloc-pile
Protector de la batería

Publicidad

Tabla de contenido
loading

Resumen de contenidos para BLACK&DECKER SPITFIRE SP1400D

  • Página 1 • Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools, with sharp cutting edge are less likely to bind and are easier to control.with sharp. • Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tools operation.
  • Página 2: Important Safety Instructions

    Unplug charger before attempting to clean. IMPORTANT SAFETY INSTRUCTIONS 7. Do not immerse charger in water or any other liquid. • SAVE THESE INSTRUCTIONS. Safety Warnings and Instructions: Drills • Before using charger, read and understand all instructions and cautionary markings on 1.
  • Página 3: Consignes De Sécurité Particulières

    recycle the battery (or battery pack) at the end of its useful life have already been paid by • Vérifier les pièces mobiles afin de s’assurer qu’elles sont bien alignées et qu’elles Black & Decker. In some areas, it is illegal to place spent nickel-cadmium batteries in the ne restent pas coincées.
  • Página 4 de service autorisé. Le remontage non conforme du produit comporte des risques Bouton à deux vitesses d’engrenage - figure 5 d’incendie ou de secousses électriques. Le bouton à deux vitesses d’engrenage permet de changer la vitesse d’engrenage, • Le chargeur est conçu pour fonctionner sur une alimentation domestique standard. Ne rendant ainsi l’outil encore plus polyvalent.
  • Página 5: Normas Generales De Seguridad - Para Todas Las Herramientas Que Funcionan Con Batería

    sustancias químicas: trabaje en una zona bien ventilada y llevando equipos de sans frais, suivant l’une des deux méthodes suivantes. seguridad aprobados, como mascarillas antipolvo especialmente diseñadas para La première méthode consiste en un échange seulement. On doit retourner le produit au filtrar partículas microscópicas.
  • Página 6 Indicadores de carga Taladrado Cambiar la unidad • Sólo use brocas afiladas. • Soporte y sujete su trabajo debidamente, como se describe en las ‘Instrucciones de seguridad. Estos cargadores han sido diseñados para detectar ciertos problemas que pueden surgir • Use el equipo de seguridad apropiado que sea necesario, como se describe en las con las unidades de alimentación, los que serían indicados por la luz roja destellando rápi- ‘Instrucciones de seguridad’.

Este manual también es adecuado para:

Spitfire sp1800d

Tabla de contenido