Adjusting The Brake - Kobalt Razor 2492277 El Manual Del Propietario

HEADLINE REPAIR AND MAINTENANCE

Adjusting the Brake

Required Tool: 10 mm Wrench (not included)
1
To adjust the brake cable play,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
Front Tire Replacement
Required Tools: Two (2) 5 mm Allen Wrenches (not included)
1
Using two (2) 5 mm Allen
wrenches, loosen the axle
bolt. Remove wheel and install
replacement wheel. (Note the
sequence of the hardware)
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
Kobalt_LowesSMU_US_MAN_200812.indd 9 Kobalt_LowesSMU_US_MAN_200812.indd 9
2
If brake is too tight or has too
much slack, use a 10 mm wrench to
loosen the brake cable and adjust
accordingly.
B
A
3
Inspect the brake pads (A) for
proper alignment against the wheel
or excess wear. To realign the brake
pads, loosen the fixing nut (B) and
adjust the pad to contact the rim.
Re-tighten and readjust as needed.
Verify proper brake function prior to
riding the scooter.
9 9
Note: Front wheel
hardware sequence.
Right Side (Throttle)
10-1 Coupling Bolt
10-2 Spacer
Left Side (Brake)
10-3 Spacer
10-4 Hex Bolt
8/12/20 1:10 PM 8/12/20 1:10 PM