Usage; How To Operate; How To Ride; How To Stop - Kobalt Razor 2492277 El Manual Del Propietario

USAGE

How to Operate

Do not activate the thumb throttle unless you are on the electric scooter and in a safe, outdoor
environment suitable for riding.

How to Ride

Once you have charged the battery (see page 5 for charging information):
1. Turn power switch "ON"; put kickstand up and place both hands on the handlebars.
2. Place one foot on deck plate and with the other foot, push (kick start) scooter (A), and then push down on the
thumb throttle (B). Place other foot on deck plate once motor has engaged.
A

How to Stop

1. To stop, release the throttle (B) and apply the brake, by squeezing the brake lever (C), until the product comes to
a complete stop.
C
Kobalt_LowesSMU_US_MAN_200812.indd 7 Kobalt_LowesSMU_US_MAN_200812.indd 7
B
B
7 7
Note: Electric scooter must be
moving at least 3 mph (5 km/h)
while engaging throttle to
engage motor.
WARNING: The brake is
capable of skidding the rear tire
and throwing an unsuspecting rider.
Practice in an open area free from
obstacles until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control and/or damage the rear tire.
Note: As an additional safety
feature, the scooter is designed to
cut power to the motor when brake
is applied.
Note: Motor will re-engage
(without having to kick to start),
if brake is released and throttle is
applied before scooter has slowed
down to under 3 mph (5 km/h).
Note: Practice riding only in wide
open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under the limited warranty.
8/12/20 1:10 PM 8/12/20 1:10 PM