Part Names - Midea FW40-F3 Manual De Uso Y Cuidado

PART NAMES

GUARD & FAN BLADE ASSEMBLY
1. Unscrew and remove the spinner clockwise (or obtain from parts bag), and the
plastic nut counterclockwise. You may have to hold the shaft in place with one
hand to unscrew the spinner with the other. Position the rearguard against the
motor face so that the two pins on the motor face fit through the matching holes
in the rearguard. Tighten the rearguard into place with the plastic nut. (Fig. 1)
2. Remove and discard the PVC sleeve from the motor shaft. Mount the blade set
onto the motor shaft through the center hole in the blade set. Insert the pin on
the motor shaft into the notches on the back of the blade set. Turn the spinner
counterclockwise onto the shaft to tighten the blade set into place. (Fig. 2)
3. Use the clips on the front guard to fasten the front and rear guard together.
(Fig. 3)
Fig.1
INSTALLATION
The fan must be installed into a wall stud or into a stable
wooden upright standing vertically from the floor.
CAUTION: To prevent the fan from falling down, be sure
to install it into a wall stud. Do not install it only into a
wall surface not backed with a stud.
Installing the mounting bracket
Fix the supplied mounting bracket firmly to the wall
using the three screws.
NOTE: The bracket should be positioned at least
14 inches from the ceiling and at least 12 inches
from adjoining wall.
Blade Set
Fig.2 Blade Set
2
Clip
Fig.3