Siemens HHB-700 HHB-710 Manual Del Usuario página 162

Federal
Communication
Commission
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any in-
terference received, including interfer-
ence that may cause undesired
operation.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protec-
tion against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the in-
structions, may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that in-
terference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or
television reception, which can be de-
termined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one of the
following measures:
• Reorient or relocate the receiving an-
tenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Federal Communication Commission (en)
Any changes or modifications not ex-
pressly approved by the party responsi-
ble for compliance could void the user's
authority to operate this equipment.
FCC Radiation Exposure Statement:
This transmitter must not be co-located
or operating in conjunction with any oth-
er antenna or transmitter.
IC Statement:
"The installer of this radio equipment
must ensure that the antenna is located
or pointed such that it does not emit RF
field in excess of Health Canada limits
for the general population; consult
Safety Code 6, obtainable from Health
Canada's website
www.hc-sc.gc.ca/rpb"
CE Statement:
Hereby, the manufacture declares that
this device is in compliance with the es-
sential requirements and other relevant
provisions of the R&TTE Directive
1999/5/EC.
This device will be sold in the following
EEA countries: Austria, Italy, Belgium,
Liechtenstein, Denmark, Luxembourg,
Finland, Netherlands, France, Norway,
Germany, Portugal, Greece, Spain, Ice-
land, Sweden, Ireland, United King-
dom, Cyprus, Czech Republic, Estonia,
Hungary, Latvia, Lithuania, Malta, Slo-
vakia, Poland, Slovenia.
161