Knape & Vogt USC12-1-35 Manual De Instrucciones

Parts Included
A. Waste Bin(s)
B. Sliding Base Assembly (1)
C. Waste Bin Chassis (1)
D. Lid(s) (if supplied)
E. #8x1/2" Mounting Screws
for Door (8 = 4 + 4 extra)
F. #8X1" Mounting Screws
for Sliding Assembly
(8 = 4 + 4 extra)
A B
C
D
E
Tools Required
• Phillips head screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Tape measure or ruler
• Pencil
• Scissors
Product Assemblies
USC12-1-35
USC12-1-50
USC15-2-35
USC18-2-50
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
SOFT-CLOSE UNDERMOUNT WASTE BIN
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
Install Sliding Base Assembly
Place sliding base assembly on cabinet floor in the
center of the cabinet opening. Position front edge
of the front mounting strap 2-1/4" back from the
outside edge of the front of the cabinet. For a fully
inset door application, measure 2-1/4" back from
inside edge of the cabinet face frame. Completely
close door to make sure the assembly will not
interfere. Once the position is determined, fasten
the sliding base assembly to cabinet floor using
4 – #8x1" mounting screws through interior holes
using a Phillips head screwdriver.
Optional Step: Mark mounting hole positions with a
pencil then remove sliding base assembly and drill
pilot holes. Place sliding assembly back into
position and fasten with #8x1" mounting screws. For
additional stability, fasten extra 4 – #8x1" mounting
screws through outside holes.
Remove Door
With drill or screwdriver, remove door hinges from
cabinet and door. IMPORTANT: Door must be
removed prior to Waste Bin Chassis installation.
Install Waste Bin Chassis
Lower and insert rear of chassis so that the
channels on the chassis fit onto the slides on the
sliding base assembly. Push chassis toward the
back of the cabinet until it sits against the back of
the slides and you hear a "click". The chassis is now
fully seated and locked. Grasp the door mount
brackets, slowly pull the chassis out of the cabinet
until it stops moving. Both slides should fully extend.
NOTE: If your slides do not fully extend, your chassis
is not seated properly. To correct, push the drawer
slide forward until it locks into position.
Determine Door Bracket Position
F
4A. Measure the door width by measuring from the
outside edge of the left door stile to the outside
edge of the right door stile. Then, determine the
center door panel width by measuring from the
inside edge of the left door stile to the inside edge
of the right door stile. These two measurements
determine the door bracket mounting area.
Locate your product assembly on the charts that
follow. Select the Outside to Outside Edge of
Brackets (Z) measurement that fits within your door
bracket mounting area. This determines if your
Brackets Face Outward or Inward, as shown on
chart.
If your door brackets face inward, go to step 5.
Note: All USC18-2-50 unit door brackets face
outward. USC18-2-50 unit is pre-assembled with
door brackets outward. Skip to Step 5.
©2010 Knape & Vogt. All rights reserved. Made in USA.
Knape & Vogt ® reserves the right to change specifi cations without notice.
2-1/4"
(5.7cm)
1
Cabinet
Opening
A
(Bottom
Door
2
Overlay)
3
Door Width
BACK OF DOOR
Center Panel
Door Panel
Width
4A
310188-C-0810