Problem
The product has no power.
The product does not operate cor-
rectly.
CAUTION: Speak to an approved servicing
dealer if the problem stays.
To prepare the product for long-term storage
Do the steps that follow if the product will be kept in
storage for more than 30 days. The procedure that
follows prevents problems with the fuel system.
1. Add a fuel stabilizer to the fuel. The fuel stabilizer
must agree with the recommendation from the
manufacturer.
2. Operate the product for 10-15 minutes.
3. Let the engine become cool and drain the fuel tank.
CAUTION: Do not keep fuel in long-term
storage. Discard gasoline that is not
clean.
4. Start the engine and let it operate until all the fuel
has been used and the product stops.
5. Let the engine become cool and replace the engine
oil.
6. Remove the spark plug cap and put ½ oz/15 ml of
engine oil into the cylinder.
12
Cause
The product is not connected to the
electrical source.
A circuit breaker has tripped.
The receptacle is engaged.
Servicing is necessary.
Problem with an electrical device.
There is too much load in the prod-
uct.
7. Put a cloth on the spark plug hole for protection.
8. Pull the starter rope handle 5 times to lubricate the
9. Install and tighten the spark plug.
10. Clean the product.
11. Put the product in a clean and dry location indoors.
12. Put a cover on the product for protection.
Solution
Stop the product and disconnect it.
Connect the product and start it
again.
Stop the product and disconnect it.
Restart the circuit breaker. Connect
the product and start it again.
Stop the product and disconnect it.
Do a test of the receptacle. If the re-
ceptacle is not damaged, start and
connect the product again.
Speak to an approved servicing deal-
er.
Disconnect the electrical device.
Speak to an approved servicing deal-
er.
Decrease the quantity of electrical
devices connected to the product.
engine parts.
WARNING: Do not install the spark plug
cap.
WARNING: Do not put a cover on the
product if it is warm.
1420 - 002 - 02.03.2020