Problems & Solutions - ZEN AROME MobySens Manual De Instrucciones

WARNING: DESPITE THE SAFETY CUT-OUT DEVICE THAT TURNS THE TRANSDUCER OFF,
AVOID LEAVING THE POWER SWITCHED ON TO THE DEVICE WHEN YOU ARE NOT USING IT.
TO STOP THE DIFFUSER COMPLETELY, UNPLUG THE UNIT FROM THE POWER SUPPLY.
III. MAINTENANCE
After using 5-6 times or 3-5 days, please clean the product as follows:
Turn of the power supply, unplug the unit and remove the nozzle.
Remove the essential oil bottle from the nozzle.
Put a little neutral detergent into the warm water to dilute, the wipe the product with duster
cloth.
If you find any dirt in the straw, please remove the straw and clean it.
If you need to change another essential oil, please clean the nozzle first.
When maintain, never use the medical dilution benzene ethanol, or it will damage the
product and destroy the mark on product.
V. PROBLEMS & SOLUTIONS
When you turn the diffuser ON but it is not working – Please check if the battery is
discharged, if the red LED light is flashing, you should charge the unit.
When it can not diffuser normally:
– Please check if the nebulizer is loose. Just put your fingers near to the nebulizer to feel if
there is airflow coming out, if not, please pull the nebulizer out and plug in well.
– Please check if the tube is loose or got stucked. Just clear the cube and assemble it well.
I. LAS INDICACIONES ESENCIALES
LEA TOTALMENTE ESTAS INSTRUCCIONES ANTES DE UTILIZAR ESTE DIFUSOR,
PARTICULARMENTE LAS INDICACIONES ESENCIALES SOBRE SEGURIDAD:
• Los botones del aparato no son resistentes al agua y no deben entrar en contacto con el
agua. No sumerja la emisora.
• Coloque siempre el difusor sobre una superficie dura, plana y horizontal
escape de los aceites esenciales.
cocina, radiadores, etc.
• Por favor use aceites esenciales convenientes para la difusión.
• No lave la unidad con agua ni la sumerja nunca en ella.
• Limpiar la superficie del difusor con un producto para el hogar adecuado para el aluminio y
el plástico. No utilice la herramienta difícil de rayar la superficie
• Compruebe que el voltaje de su red se corresponde con el del aparato.
MANUAL DE INSTRUCCIONES
Aléjelo un poco de las paredes y de fuentes de calor como
para evitar el
5