Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY AND INSTALLATION:
INSTALLATION (Fig. 1)
1.
Unscrew the lock nuts [B] from the fixture screws [G], but leave the fixture screws
[G] and hex nuts [E] on the mounting bracket [D].
2.
Pull the power supply wires [H, J, & L] out from the outlet box [O], and attach the
mounting bracket [D] to the outlet box [O], using the mounting screws [F].
3.
NOTE: This product is not for use with rectangular junction boxes.
4.
Strip approximately 63 mm / 0.25 in / 0.25 po of insulation from each supply wire from
the outlet box [O]. Raise the fixture [A] to the wall, bringing the wall plate [N] close to
the outlet box [O]. Make the following wire connections using the wire nuts [C]:
[H] White (neutral) supply wire to
[J] Black (hot) supply wire
[L] Supply ground wire
Wrap each wire connection with 5 cm / 2 in / 2 po of electrical tape.
A
N
Fig. 1
F
I
B
M
A. Fixture
B. Lock Nut
C. Wire Nut
D. Mounting Bracket
E. Hex Nut
F. Mounting Screw
G. Fixture Screw
H. White Supply Wire
[I] White fixture wire
to
[K] Black fixture wire
to
[M] Fixture ground wire
D
E
C
K
I.
White Fixture Wire
J. Black Supply Wire
K. Black Fixture Wire
L. Supply Ground Wire
M. Fixture Ground Wire
N. Wall Plate
O. Outlet Box
4
J
G
L
O
H
Publicidad
Tabla de contenido
