BGS technic 70040 Guia De Inicio Rapido página 5

COMPONENTS
1 Lifting ram with saddle
2 Carrying handle
3 Operating handle
4 Socket for operating handle (raising)
5 Release valve (lowering)
INSPECTION
The product shall be maintained in accordance with the product instructions.
No alterations shall be made to this product.
•
Before use, a visual inspection of the jack should be made for abnormal conditions such as
cracked welds, damage, bent, worn, loosen or missing parts, or hydraulic leaks.
•
The product shall be inspected immediately if the jack is believed to have been subject to an
abnormal load or shock. It is recommended that this inspection be made by an authorized
customer service representative prior to use.
RAISING VEHICLE
1. Make sure the jack and vehicle are on a hard level surface.
2. Always set the vehicle parking brake and block the wheels
3. Consult the vehicles owner manual to ascertain the location of jack points and position the jack
beneath the prescribed lift point.
4. Turn the release valve clockwise to the closed position. Do not over tighten!
5. To raise the vehicle to designed height, place the handle into the socket and pump up and down.
6. Place jack stands beneath the vehicle at locations recommended by the vehicle manufacturer. Do
not get under the vehicle without jack stands. This hydraulic jack is not designed to maintain
heavy loads for long periods of time. Do not attempt to put jack stand simultaneously under both
ends of vehicle or under one side of vehicle.
7. Turn release valve SLOWLY counterclockwise to lower load onto jack stands.
LOWERING VEHICLE
1. Turn the release valve clockwise to the closed position.
2. Pump the handle to lift vehicle off of jack stands.
3. Remove the jack stands. Do not get under or let anyone else under the vehicle while lowering.
4. Turn the release valve SLOWLY counterclockwise to lower the vehicle onto the ground.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed